Roland 04672434 用户手册
56
Chapter 5 Using MIDI
The table below shows the correspondence between the factory
default Program change Map and the Program Change messages
received when RX PC MAP is set to FIX.
default Program change Map and the Program Change messages
received when RX PC MAP is set to FIX.
*
When setting
transmit channel beforehand.
Setting the MIDI Output Control
Change Number
Change Number
This sets the Control Change numbers output when the VB-99’s
pedals and external pedals or the FC-300’s pedals and external
pedals are operated.
pedals and external pedals or the FC-300’s pedals and external
pedals are operated.
1.
2.
Press PAGE [
] [
] to display Page 7.
The TX CC screen appears.
3.
Use [F2] (SEL
) or [F3] (SEL
), the F2 or F3
knobs to select the controller you want to set.
4.
Use [F5] or the F5 knob to assign the Control
Change number to be transmitted when the
controller is adjusted.
Change number to be transmitted when the
controller is adjusted.
When the controller selected with F2 or F3 is operated, the
Control Change message selected with F5 is transmitted.
Control Change message selected with F5 is transmitted.
*
Control Changes message cannot be output if OFF is selected.
Bulk Dump
With the VB-99, you can use Exclusive messages to set another VB-99
to the same settings or to save effect sound settings to MIDI
sequencers and other such devices.
to the same settings or to save effect sound settings to MIDI
sequencers and other such devices.
This transmission of data is referred to as bulk dump.
Data that can be transmitted is described below.
How to Transmit the Data
When Saving Data to a MIDI Sequencer
Connect the devices as shown below, then place the MIDI sequencer
in standby mode, so it is ready to receive Exclusive messages.
in standby mode, so it is ready to receive Exclusive messages.
For information on how to operate the sequencer you are
using, refer to the owner’s manual that came with it.
using, refer to the owner’s manual that came with it.
Bank Select Program
Number
Patch
Number
Number
0
1
001
:
:
:
0
128
128
1
1
101
:
:
:
2
128
328
3
1
301
:
:
:
3
100
400
Displayed
Data Transmitted
ALL
All transmittable data (SYSTEM, GK SETTING,
GLOBAL, PATCH 001–200, FAVORITE SET-
TING)
GLOBAL, PATCH 001–200, FAVORITE SET-
TING)
SYSTEM
SYSTEM parameters.
GK SETTING
Settings content for GK SETTING
GLOBAL
GLOBAL function settings
PATCH
Settings for patch numbers 001–200
FAVORITE
SETTING
SETTING
Settings content in FAVORITE SETTINGS 01–
10 for all effects
10 for all effects
MIDI IN
MIDI OUT
VB-99_e.book 56 ページ ２００８年８月１８日 月曜日 午後１時１０分