Roland 04672434 用户手册

Chapter 6 Using the VB-99 Connected to a Computer Via USB

In the computer application, set the audio input port to the VB-99.

You can freely set the point at which signals are sent to the computer
with

For example, by selecting COSM BASS A or COSM BASS B, you can
listen to the performance with the effects applied, while recording it
without the effects.

If passing audio data through the software you’re using, switch the

direct monitor off.

Parameter/
Range

Explanation

MON CMD (Monitor Command)

This setting determines whether or not the command (the Direct
Monitor command) controlling the Direct Monitor (described later)
setting is enabled.

DISABL

The Direct Monitor command is disabled,
maintaining the Direct Monitor mode set by
the VB-99.

ENABLE

The Direct Monitor command is enabled, al-
lowing the Direct Monitor mode to be
switched from an external device.

DIRECT MON (Direct Monitor)

Switches the output of the VB-99 sound to the PHONES jack, MAIN
OUT jacks, or SUB OUT jacks.

OFF

Set this to Off if transmitting audio data in-
ternally through a computer (Thru).

The VB-99 sound is output. Set this to On
when using the VB-99 as a standalone de-
vice, without connecting to a computer
(only USB IN input sound will be output if
this is set to Off).

* This setting cannot be saved. It is set to ON when the power is turned

on.

* If you are using the special driver, you can control DIRECT MON On/

Off from ASIO 2.0-compatible application.

Audio signal

DIRECT MON

MAIN or SUB

USB OUT

USB IN

Audio OUT

Audio IN

VB-99 sound

Computer

Headphones

Bass Amp

Mixer

Recording the VB-99’s
Output with a Computer

VB-99_e.book 68 ページ２００８年８月１８日　月曜日　午後１時１０分