Roland 04672434 用户手册
72
Chapter 7 Other Functions
4.
To turn off the D Beam controller, press the
button you pressed in Step 1 again so the
indicator goes off.
button you pressed in Step 1 again so the
indicator goes off.
While the ribbon controller has been adjusted at the factory for
optimum performance, the responsive range may vary with the
width of the finger used to activate the controller.
optimum performance, the responsive range may vary with the
width of the finger used to activate the controller.
If this occurs, use the procedure below to readjust the range.
1.
Press [SYSTEM].
2.
Press PAGE [
] [
] to go to Page 2.
3.
Press [F6] (CALIB).
4.
Press PAGE [
] to go to Page 2.
The RIBBON CALIB screen appears.
5.
Set the responsive range as you actually
operate the ribbon controller.
operate the ribbon controller.
• First, while holding your finger against the near end of the
ribbon controller, press [F1] (SetMIN).
• Next, hold your finger against the far end and press [F4]
(SetMAX).
If the message “OUT OF RANGE! SET AGAIN.” is displayed,
carry out the calibration process once more. If the message
continues to appear even after the calibration is correctly
performed, it may indicate damage or malfunction. Consult
your Roland dealer or contact Roland Service.
carry out the calibration process once more. If the message
continues to appear even after the calibration is correctly
performed, it may indicate damage or malfunction. Consult
your Roland dealer or contact Roland Service.
6.
Press [EXIT] several times to return to the Play
screen.
screen.
The CALIBRATION setting is a system parameter, so the
Write procedure is not required.
Write procedure is not required.
Effective Range of the D Beam Controller
The D Beam controller’s effective range is shown in the figure
below. Moving your hand outside this effective range produces
no effect.
below. Moving your hand outside this effective range produces
no effect.
The effective range of the D Beam controller will be
extremely limited when used under strong, direct
sunlight. Please be aware of this when using the D
Beam controller outdoors.
extremely limited when used under strong, direct
sunlight. Please be aware of this when using the D
Beam controller outdoors.
The sensitivity of the D Beam controller can vary
depending on the amount of light in the vicinity of
the unit. If it does not function as you expect, adjust
the D Beam.(p. 70)
depending on the amount of light in the vicinity of
the unit. If it does not function as you expect, adjust
the D Beam.(p. 70)
The parameter values set by holding your hand or
other object over the D Beam controller change as
shown below.
other object over the D Beam controller change as
shown below.
D BEAM vertical
movements
movements
Explanation
Closer to the D Beam
The value approaches the MAX value.
Farther from the D
Beam
Beam
The value approaches the MIN value.
D BEAM horizontal
movements
movements
Explanation
To the right of the D
Beam
Beam
The value approaches the MAX value.
To the left of the D
Beam
Beam
The value approaches the MIN value.
Adjusting the Ribbon Controller
(CALIBRATION)
(CALIBRATION)
VB-99_e.book 72 ページ ２００８年８月１８日 月曜日 午後１時１０分