Roland VS-700 用户手册

 

Creating a Rhythm Set

 

You can set the volume of the waveform.

 

 0–127

 

The volume level of each rhythm tone is set with the 

Tone Level parameter; the volume levels of the entire 

 

This specifies the pan of the waveform. “L64” is far left, “0” is 

center, and “63R” is far right.

 

 L63–0–63R

 

Use this setting to cause the waveform’s panning to change 

randomly each time a key is pressed (ON) or not (OFF).

 

 OFF, 

ON

* The range of the panning change is set by the Rnd Pan Depth 

 

This setting causes panning of the waveform to be alternated 

between left and right each time a key is pressed. Set 

Alternate Pan Switch to “ON” to pan the Wave according to 

when you want the panning reversed. If you do not want the 

panning to change each time a key is pressed, set this to 

“OFF.”

 

 

OFF, ON, REV

The WMT (Wave Mix Table) uses key velocity to control the 

four waveforms assigned to the rhythm tone.

 

WMT Velocity Control determines whether a different rhythm 

tone is played (ON) or not (OFF) depending on the force with 

which the key is played (velocity).

When set to “RND,” the rhythm set’s constituent rhythm 

tones will sound randomly, regardless of any Velocity 

messages.

 

 

OFF, ON, RANDOM

 

This determines what will happen to the tone’s level when 

the tone is played at a velocity lower than its specified 

velocity range. Higher settings produce a more gradual 

change in volume. If you want notes played outside the 

specified key velocity range to not be sounded at all, set this 

to “0.”

 

 0–127

 

This sets the lowest velocity at which the waveform will 

sound. Make these settings when you want different 

waveforms to sound in response to notes played at different 

strengths.

 

 1–UPPER

 

Changing How a Rhythm Tone is 
Sounded (WMT)

VS-700_r_e.book 128 ページ ２００８年１１月２０日　木曜日　午後２時２８分