Roland 5100012850-01 用户手册

23 USB FOR UPDATE Connector

This is used to update the VP-7’s internal program.

NOTE

For normal use, do not connect anything to this connec-

tor.

12 [POWER] Switch (p . 15)

This turns the power of the VP-7 on/off.

13 DC IN Jack (p . 10)

Connect the AC adaptor here.

14 MIDI IN Connector (p . 11)

Connect your MIDI device here.

15 FOOT PEDAL Jack (p . 14, p . 24)

Connect a foot pedal here.

This lets you use a foot pedal to control the function of the [Bypass]

button.

16 [TUNE] Knob (p . 26)

This knob adjusts the tuning.

You can adjust the tuning over a range of 438–442 Hz in 1 Hz steps.

17 [PHANTOM] Switch (p . 13)

Turn this on if you’ve connected a condenser microphone that

requires phantom power.

* Turn this off if you’re using the included microphone (DR-HS5) .
* Supplying phantom power to a dynamic microphone or audio

playback device will cause malfunctions .

18 MIC IN Jack (both XLR and 1/4” phone) (p . 13)

Connect your microphone here.

The Mic input connector supports either XLR type or phone type

plugs.

The XLR type connector supports 48V phantom power, allowing you

to connect a condenser microphone that requires a phantom power

supply.

19 LINE INPUT Jack (STEREO) (p . 28)

Here you can connect your portable audio player or the audio

output of your MIDI-connected keyboard.

* The VP-7’s [Volume] knob does not affect the LINE INPUT . Use the

volume control of the connected keyboard to adjust the volume .

20 OUTPUT Jacks (p . 12)

These jacks output the VP-7’s sound in stereo (L/R).

927

21 Ground Terminal

Depending on the circumstances of a particular setup, you may

experience a discomforting sensation, or perceive that the surface

feels gritty to the touch when you touch this device, microphones

connected to it, or the metal portions of other objects, such as

guitars. This is due to an infinitesimal electrical charge, which is

absolutely harmless. However, if you are concerned about this, con-

nect the ground terminal (see figure) with an external ground. When

the unit is grounded, a slight hum may occur, depending on the

particulars of your installation. If you are unsure of the connection

method, contact the nearest Roland Service Center, or an authorized

Roland distributor, as listed on the “Information” page.
Unsuitable places for connection

• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in

the event of lightning)

988

22 Security Slot ( )

• http://www.kensington.com/

Bottom Panel

Rear Panel