American Dj Rover 用户手册

©

American DJ Supply

®

  -  www.americandj.com  - Rover™ Instruction Manual Page 6

©

American DJ Supply

®

  -  www.americandj.com  - Rover™ Instruction Manual Page 5

Listed  below  are  a  few  common  problems  that  you  may  encounter, 

with solutions.

1.  Be sure you have connected your unit into a standard 110V wall 

     outlet.  

2.  Be sure the external fuse has not blown. The fuse is located on 

     the rear panel. 

3.  Remove the lamp cover and be sure the lamp is seated in its socket 

     properly. Occasionally lamps become loose during shipping be 

     sure the lamp is push in to its socket all the way. 

 

1.  Be sure the unit's mode switch is in the "I" position, this is the only 

     mode that allows the unit to operate in sound active mode.  

2.  Low frequencies (bass) should cause the unit to react to sound. 

     Tapping on the microphone, quiet or high pitched sounds may not   

     activate the unit.  

  Rover™ Trouble Shooting

  Rover™ Cleaning

Disconnect  from  the  main  power  supply. Be  sure  the  unit  has  had 

ample time to cool before attempting to replace the lamp. On the front 

of the unit there is a single thumb screw. Remove the thumb screw and 

pull back the front case housing. The housing is hinged which allows 

it to pull back without being removed. Remove the old lamp from the 

socket  assembly. Carefully  install  the  new  lamp,  be  sure  to  follow  all 

the installation guide lines that are included with your new lamp. Close 

the front cover and replace the thumb screw.

  Always  replace  with  the  exact  same  type  lamp  and  fuse, 

unless otherwise specified by an authorized American DJ

®

 technician.

Remove the thumb screw on the rear of the unit as illustrated below.

Remove the lamp from the socket and insert a new one as illustrated above.