Roland HD-1 用户手册
17
Replacing a Pad
If it’s necessary to replace the head on the snare, follow these
instructions:
instructions:
Optional replacement head: MH-8 Mesh Head
fig.replace-snare-e
The sensor and cushion under the head are very sensitive. Put no
pressure on these parts as it may disrupt the proper functioning of
the pad.
pressure on these parts as it may disrupt the proper functioning of
the pad.
1.
Remove all the tuning bolts.
2.
Remove the hoop.
3.
Take off the old head.
4.
Place the new head on the shell.
5.
Mount the hoop.
6.
• Do not firmly tighten a single tuning bolt by itself. Doing so will
make it impossible to tension the head evenly, and will cause
malfunctions.
malfunctions.
• Due to the nature of the materials used in the sensor, changes
in room temperature may affect the sensitivity of the sensor.
• The rubber portion of the striking surface is treated with a
preservative to maintain its performance. With the passage of
time, this preservative may appear on the surface as a white
stain, or reveal how the pads were struck during product
testing. This does not affect the performance or functionality of
the product, and you may continue using it with confidence.
time, this preservative may appear on the surface as a white
stain, or reveal how the pads were struck during product
testing. This does not affect the performance or functionality of
the product, and you may continue using it with confidence.
Replacing the Snare Head
Drum Key
Hoop
Head
Hoop’s Rubber
Portion
Portion
Sensor
Loosen
Tighten
Shell
Tuning Bolt
HD-1_r_e.book 17 ページ ２００７年３月２８日 水曜日 午後６時５８分