Roland TD-9 用户手册

Getting ready to play

* Once connections have been made (p. 17), turn on the power to the connected equipment in the order specified. Doing it in the

wrong order raises the risk of damage/malfunction to that equipment.

1. Turn [VOLUME] all the way to the left.

2. Do the same with the connected amp or audio

system.

3. Press [POWER].

After a time, [POWER] will light.

* The TD-9 is equipped with a protection circuit and requires

a brief interval a few seconds) after powering before it will
operate normally.

4. Power-on the connected amp or audio system.

5. While hitting a pad, gradually turn [VOLUME]

toward the right to adjust the volume.

Adjust the volume of the connected amp/ audio system to
the desired level.

Turning the power off

1. Turn the volume down on the TD-9 and any

connected equipment.

2. Power-off the connected equipment.

3. Hold down [POWER] until the screen indicates

“POWER OFF.”

After a moment, [POWER] goes dark.

Turning the power on/off

Caution when turning on the power

After you turn on the power, do NOT touch any pads or
pedals until the drum kit name (the illustration below) has
appeared in the display. Doing so can cause various
problems.

If you don’t hear any sound

Check the following points.

Pad and pedal connections

• Is the cable correctly connected to the TRIGGER

INPUT connector?

• Are the cables correctly connected to each pad or

pedal?

When using an amp or audio system

• Are the TD-9’s OUTPUT jacks connected correctly to

the input jacks of your amp/audio system?

• Are the input selections and volume settings correct on

that amp/audio system?

• Possible problem with the connection cables

themselves?

• Isn’t the [VOLUME] turned all the way to the left?
• Have the input select settings of your audio system or

amp been made correctly?

• Is the amp or audio system volume setting correct?

When using headphones

• Are your headphones plugged into PHONES jack?

TD-9_e.book 18 ページ２００８年１月２３日　水曜日　午後４時２４分