Roland TD-9 用户手册

 

OFF, 
MODULATION(1), 
FOOT(4), 
GENERAL1(16)

Specifies the MIDI control change message used to transmit/receive the depth to 
which the hi-hat pedal is pressed.

 

TD-9/TD-20, 
EXTERNAL

This is a setting for the MIDI messages transmitted when you’re using an external MIDI 
sound module to sound the notes played by the TD-9 and pads.

 

Choose this setting if you’re using just the TD-9 and pads, or if you’re using a TD series 
unit such as the TD-9 or TD-20 as your MIDI sound module.
MIDI messages appropriate for the TD series will be transmitted.

 

Choose this setting if you’re using an external MIDI sound module other than the TD 
series.
If you choose this setting, the display will indicate “HH Note# Border.”

 

0–127

This setting lets you transmit MIDI messages that are appropriate for the MIDI sound 
module you're using.

The note number transmitted when you strike the hi-hat will change depending on the 
amount of pressure on the hi-hat pedal.
HH Border allows you to adjust the pedal position at which the note number switches 
from the open hi-hat to the closed hi-hat.
As you monitor the note number transmitted by the TD-9 and the Control Change mes-
sage value, adjust the setting until the note number is switched at the pedal position 
you want.
When using a VH-11 for the hi-hat, setting this value to around 80 allows you to trans-
mit the closed hi-hat note
number when the pedal is slightly above the fully depressed position.

 

If you change the HH Border setting, the hi-hat of a pattern that was recorded 
onto the internal sequencer by playing the pads may play back in a way that is 
different from the actually recorded performance.

TD-9_e.book 53 ページ ２００８年１月２３日　水曜日　午後４時２４分