Roland PD-105X 用户手册

• Applying excessive force to the sensor located under

the head can damage it and/or interfere with

accurate triggering.

• Be careful not to hurt your fingers on the corners or

points of the metal parts.

Loosen all tuning bolts, and remove the hoop and

head.

Remove the frame.

Use a Philips screwdriver to loosen the screw that

fastens the covering by approximately two full turns.

Pull the fastening clip upward and out, and remove

the covering.

Attach the new covering.

Insert the lower part of the covering into the rubber groove

so that the upper edge of the covering is in the position

shown in the illustration.

Both edges of the covering will fit into the gap between the

shell and plate.

While pulling on both ends of the covering so as to

eliminate any slack, finger-tighten the screw that

holds the covering in place.

Using a Philips screwdriver, securely fasten the

screw that holds the covering in place.

Attach the fastening clip in the location shown in the

illustration, as if to pinch the two ends of the covering.

Replacing the Shell Covering

Do not touch the sensor located
at the top of the frame.

Head

Hoop

Frame

Screw

Covering

Fastening Clip

The upper edge
of the covering

Shell

Screw

Covering

Plate

Fastening clip

PD-125X_125XS_105X_e.book 8 ページ２００９年５月１８日　月曜日　午前９時２３分