Craftsman 247.77099 用户手册

下载
页码 52
14
Change engine oil after the first five hours of 
operation, and every twenty-five hours thereafter. 
TO DRAIN OIL
Drain oil while engine is warm. Follow the instructions 
given below:
Drain the fuel from the tank by running the engine 
until the fuel tank is empty.
Remove oil fill dipstick.
Tip unit on its side to drain through the oil fill tube.   
When engine is drained of all oil, refill with 
approximately 18 oz. of fresh oil. Refer to Gas 
And Oil Fill-up
 in OPERATION section. 
Replace oil fill dipstick and tighten. 
SERVICE AIR CLEANER 
The air cleaner prevents damaging dirt, dust, etc., 
from entering the carburetor and being forced into the 
engine and is important to engine life and 
performance. The air cleaner consists of a pleated 
filter. Never run the engine without an air cleaner 
completely assembled. 
To Service Air Cleaner: 
Loosen screw and tilt plastic housing cover on 
side of engine down. See Figure 14.
Remove pleated filter from plastic housing cover 
and replace with clean or new filter.
Tilt cover up into place and tighten screw.
Figure 14
NOTE: 
If the filter is torn or damaged in any way,
replace it. 
WARNING: 
Temperature of muffler
and nearby areas may exceed 150
o
 
F
(65
o
C). Avoid these areas.
 Air Cleaner
Housing
SERVICE SPARK PLUG 
Clean the spark plug and reset the gap to.030" at 
least once a season or every 50 hours of 
operation. See Figure 15. Spark plug 
replacement is recommended at the start of each 
season. Refer to engine parts list for correct 
spark plug type. 
NOTE: 
Do not sandblast spark plug. Spark plug
should be cleaned by scraping or wire brushing and
washing with a commercial solvent.
Figure 15
SERVICE MUFFLER
Inspect muffler periodically, and replace if 
necessary. 
If your engine is equipped with a spark arrester 
screen assembly, remove after every 50 hours of 
use for cleaning and inspection. Replace if 
damaged.
WARNING: 
Do not operate the Yard
Vacuum without a muffler or tamper with
the exhaust system. Damaged mufflers
or spark arresters could create a fire
hazard.
CLEAN ENGINE
Clean engine by removing dirt and debris with a 
cloth or brush.
Frequently remove grass clippings, dirt, and 
debris from cooling fins, air intake screen, levers, 
and linkage. This will help ensure adequate 
cooling and engine speed. 
 
Spark Plug
.030" Gap Gauge