Husqvarna FT900 用户手册

•  Loosen nut “A”.
•  Insert stake support between engine bracket halves 

with stake spring down. 

•  Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tighten se curely. Tighten nut “A”.

•  Depth stake must move freely. If it does not, loosen 

support bolt.

depth_st

ak

e_4

• 

Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just -

ments section of this manual).

•  Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 

Ser vice and Adjustments section of this manual).

• 

Check tine operation before first use.  (See “TINE OP-

ERATION CHECK” in the Service and Adjustments 

section of this manual). 

IMPORTANT: 

WHEN UNPACKING AND AS SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S).

•  Cut cable ties securing handles.
• 

Slowly lift  handle as sem bly up, route cable(s) as shown  

and align han dle holes with handle panel hole and slot.

•  Loosely assemble hardware as shown.  Be sure the

shorter (1" long) hex bolt is assembled in lower hole 

of handle.  Repeat for opposite side.   Tight en all 

hardware se cure ly. 

•  Cut cable ties securing tiller to skid and remove tiller 

from skid.

•  Remove screws securing depth stake to skid and 

discard the screws.

&4

(ANDLEª0ANEL?