Husqvarna 650CRT 用户手册

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come
into contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 20)

Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
•      First loosen handle lock lever.
•      Handle can be positioned at different settings between

“HIGH” and “LOW” positions.

• Retighten handle lock lever securely after adjusting.

FIG. 20

HANDLE
(LOW POSITION)

TIRE CARE

CAUTION: When mounting tires, un-
less beads are seated, over in fl a tion can
cause an explosion.

• Maintain 20 PSI (1.4 kg/cm

) of tire pressure. If tire

pres sures are not equal, tiller will pull to one side.

• Keep tires free of gasoline or oil which can damage

rubber.

TO REMOVE WHEEL (See Fig. 21)

• Place blocks under trans mis sion to keep tiller from

tipping.

• Remove outer side shield by removing nuts “A” and

“B”.

• Remove inner side shield by removing nuts “C” and

“D”.

•      Remove hairpin clip and clevis pin from wheel.
•      Remove wheel and tire.
•      Repair tire and reassemble.

CLEVIS
PIN

IN NER SIDE
SHIELD

OUTER SIDE
SHIELD

NUT
“D”

HAIR PIN
CLIP

NUT “C”

NUT “A”

NUT “B”

FIG. 21

HANDLE LOCK
LEVER

HANDLE
(HIGH POSITION)

FIG. 22

SCREW
AND
WASHER

HEX NUT
AND
WASHER
(LOCATED
BEHIND
TIRE)

BELT GUARD

SCREW
AND WASHER

HAIRPIN CLIP AND
CLEVIS PIN

TO REMOVE BELT GUARD (See Fig. 22)

NOTE: For ease of removal, remove hairpin clip and
clevis pin from left wheel. Pull wheel out from tiller about
1 inch.
• Remove two (2) screws from side of belt guard.
• Remove hex nut and washer from bottom of belt guard

(located behind wheel).

• Pull belt guard out and away from unit.
• Replace belt guard by reversing above procedure.