Husqvarna 650CRT 用户手册

下载
页码 28
18
Immediately prepare your tiller for storage at the end of the 
season or if the unit will not be used for 30 days or more.
CAUTION:  Never store the tiller with 
gasoline in the tank inside a build ing 
where fumes may reach an open fl ame 
or spark.  Allow the engine to cool before 
storing in any en clo sure.
TILLER
•         Clean entire tiller (See “CLEANING” in the Maintenance 
section of this manual).
•     Inspect and replace belts, if necessary (See belt re-
 place ment instructions in the Service and Ad just ments 
section of this manual).
•      Lubricate as shown in the Maintenance section of this 
manual.
•     Be sure that all nuts, bolts and screws are securely 
fastened.  Inspect moving parts for damage, break age 
and wear.  Replace if necessary.
•     Touch up all rusted or chipped paint surfaces; sand 
lightly before painting.
ENGINE
FUEL SYSTEM
IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS 
FROM FORMING IN ES SEN TIAL FUEL SYS TEM PARTS SUCH 
AS THE CAR BU RE TOR, FUEL FILTER, FUEL HOSE, OR TANK 
DURING STOR AGE. ALSO, EXPERIENCE INDICATES THAT 
AL CO HOL BLENDED FUELS (CALLED GASOHOL OR USING 
ETHA NOL OR METHA NOL) CAN ATTRACT MOIS TURE WHICH 
LEADS TO SEPA RA TION AND FORMATION OF ACIDS DUR ING 
STOR AGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM 
OF AN ENGINE WHILE IN STOR AGE.
•      Drain the fuel tank.
•     Start the engine and let it run until the fuel lines and 
carburetor are empty.
•         Never use engine or carburetor cleaner products in the 
fuel tank or permanent damage may occur.
•      Use fresh fuel next season.
NOTE:  Fuel stabilizer is an acceptable alternative in mini-
mizing the formation of fuel gum deposits during stor age.  
Add stabilizer to gasoline in fuel tank or stor age container.  
Always follow the mix ratio found on stabilizer container.  
Run engine at least 10 minutes after adding stabilizer to 
allow the stabilizer to reach the carburetor.  Do not drain 
the gas tank and car bu re tor if using fuel stabilizer. 
ENGINE OIL
Drain oil (with engine warm) and replace with clean oil.  (See 
“ENGINE” in the Maintenance section of this man ual).
CYLINDER(S)
•      Remove spark plug.
•      Pour 1 ounce (29 ml) of oil through spark plug hole into 
cylinder.
•     Pull starter handle slowly several times to distribute 
oil.
•      Replace with new spark plug.
OTHER
•         Do not store gasoline from one season to an-
other.  
•     Replace your gasoline can if your can starts to rust.  
Rust and/or dirt in your gasoline will cause problems.
•      If possible, store your unit indoors and cover it to give 
protection from dust and dirt.
•     Cover your unit with a suitable protective cover that 
does not retain moisture.  Do not use plastic.  Plastic 
cannot breathe which allows condensation to form and 
will cause your unit to rust.
IMPORTANT: NEVER COVER TILLER WHILE EN GINE AND 
EX HAUST AREAS ARE STILL WARM. 
STORAGE