EarthQuake 3365PSCE 用户手册

1.  Open top of carton and remove handlebar assembly.
2.  Find  parts  packet.  Parts  packet  for  3365/3365B/3365K/3365CE 

contains:

  6- 5/16-18 x 1-3/4” bolts 
  6- 5/16” spring lockwashers
  2- hand knobs
  4- locknuts
  2- 1/2” push nuts
  1- detent pin
 

Parts packet for 3365PS/3365KPS/R3365H/3365PSCE con-
tains:

  2- 3/8-16 x 1” bolts 
  2- 3/8-16 biway locknuts
  2- 5/16-18 x 1” bolts
  4- 5/16-18 x 1-3/4” bolts
  6- 5/16” spring lockwashers
  2- hand knobs
  4- 5/16” locknuts
  2- 1/2” push nuts
  1- detent pin
3.  Cut open end of carton and remove machine:
  a.  Install wheels on each end of axle; tap on push nuts with a  

  hammer.

  b.  Assemble tines to unit, inside tines first. Sharp edge of tine  

  will be away from operator at top, or face down at front of  

  machine.

  c.  Outside tines have two positions- wide 21” and narrow 16”.  

  For narrow width, assemble with short side of tine holder pipe  

  towards center of machine.

  d.  For wide width, move the left tine to the right side and right  

  tine to the left side.  Assemble with the long half of tine pipe  

  towards machine.

  e.  Slide the top handle of handlebar over the lower loop. Put  

  5/16-18 x 1-3/4” bolts through both holes from inside out; 

  put on 5/16” spring lockwashers and tighten with hand    

  knobs. Models 3365PS, 3365KPS,  and R3365H will use  

  3/8-16 x 1” bolts with nuts and 5/16-18 x 1”  

 

 

  bolts with hand knobs.  See parts explosion on page 19.

  f.  Check upper and lower jam nuts for tightness. See page 9,  

  Belt Tension Adjustment.

  g.  Add and check engine oil.

1.  Install the depth regulator lever through hole in bracket from the 

bottom up with curve to rear of unit and secure with detent pin.

1.  Add oil according to engine manual. 

do not overfill. Use a clean, high 

quality detergent oil. Container must be marked A.P.I. Service SF - SJ. 

Use no special additives with recommended oils. 

gasoline. Oil level must be full. Check the oil level by removing oil fill 
plug. Oil level should be up to the bottom of the fill plug opening.

2.  Always check oil level before starting engine. Refer to engine manual 

for capacity and type of oil to use.

upper 

handlebar

!

lower 

handlebar 

loop

hand knob

depth 

regulator 

lever

detent pin