Husqvarna TS200FR 用户手册

NOTE:  If at a high altitude (Above 3000 feet) or in cold 
temperatures (below 32°F), the carburetor fuel mixture may 
need to be adjusted for best engine performance. See “TO 
ADJUST CARBURETOR” in the Service and Ad just ments 
section of this manual.

The most effi cient tillage is obtained when tiller engine is 
operated at full throttle. The sound of tiller engine will tell 
you when tiller engine is lightly loaded.  Raise gauge wheels 
to increase tilling depth. If engine seems to be overloaded 
or stalls out, lower gauge wheels for shallower tilling.

Operate tiller engine at full throttle and operate tractor in 
slowest forward speed, with tractor engine at idle speed or 
just above idle. You will soon learn the proper combination 
of tilling depth and speed for good tillage.

Soil conditions will determine how deep tiller can penetrate 
on the fi rst pass. In extremely hard ground, several passes 
may be necessary to till to a depth of 5 inches while in 
soft ground, tiller may penetrate to a depth of 5 inches in 
the fi rst pass.

Set gauge wheels so that tiller will penetrate soil to a 
depth of 2 to 3 inches. Place rivet in the second or third 
hole from the bottom to attain this depth. The tiller engine 
should be run at full throttle except when cultivating small 
plants, a slower engine speed is necessary to prevent 
burying the plants.

Always dis en gage tine clutch lever (Fig. 3) and stop engine 
when traveling to or from fi eld (garden) or when not tilling.

Lift tiller out of the ground when turning corners.

Do not put tractor in reverse gear while tiller is in the ground.

Before leaving tractor seat, stop tractor, shift tractor to 
“NEUTRAL” position, throttle down and stop tractor en gine, 
set parking brake, remove ignition key and then dis en gage 
tine clutch lever, throttle down and stop tiller engine, lower 
tiller to ground.  Disconnect spark plug.

Disconnect spark plug wires before making any ad just -
ments, repairs or to remove debris in tines.

WARNING: Experience indicates that alcohol blended fuels 
called gasohol or using ethanol or methanol) can attract 
moisture which leads to separation and formation of acids 
during storage. Acidic gas can damage the fuel system 
of an engine while in storage. To avoid engine problems, 
the fuel system should be emptied before storage of 30 
days or longer. Drain the gas tank, start the engine and 
let it run until the fuel lines and carburetor are empty. 
Use fresh fuel next season. See Storage sections of this 
manual for additional information. Never use engine or 
carburetor cleaner products in the fuel tank or permanent 
damage may occur.

•      Make sure spark plug wire is connected to spark plug.
•      Move choke control lever to “FULL CHOKE” position 

for cold engine start. For warm engine start do not 
use choke control.

•      Move tiller engine throttle to midway between “FAST” 

and “SLOW” positions.

•     Grasp starter handle and pull rope out slowly until 

engine reaches start of compression cycle (rope will 
pull slightly harder at this point).

•      Pull rope with a rapid, continuous, full arm stroke. Keep 

a fi rm grip on starter handle and let rope rewind slowly.  
Do not let starter handle snap back against starter.

•     When engine starts, slowly move choke control on 

en gine “1/2 CHOKE” position and then to “NO CHOKE” 
position as engine warms up.

•      Move throttle control to desired running position.
•     Allow engine to warm up for a few minutes before 

engaging tines.