Troy-Bilt 340 用户手册

Disconnect the spark plug wire and 

ground it against the engine before performing any 

repairs.

Refer to the separate Engine Operator’s Manual for engine 

maintenance instructions.

Clean the underside of the tine shield after each use. The dirt 

washes off the tines easier if rinsed off immediately instead of 

after it dries. Always towel dry the tiller afterwards and apply a 

light coat of oil or silicone to prevent rusting or water damage.
NOTE: Never use a “pressure washer” to clean your tiller. Water 

can penetrate tight areas of the tiller and its chain case and cause 

serious damage to machine.

Remove the belt cover and lubricate all the pivot points and 

linkages at least once a season with light oil. Keep the belts free 

of lubrication.

Remove the tine assemblies and lubricate the tine shafts at least 

once a season.

Remove the wheel assemblies and lubricate the axle shafts at 

least once a season.

The chain drive is pre-lubricated and sealed at factory.

Refer to the Assembly & Set-Up section of this manual  for 

instructions on adjusting the forward and reverse cables.

With the outer tines installed, the working width of the machine 

is 24 inches. This width may be expanded to 26 inches by 

removing the clevis and cotter pins, sliding each outer tine 

outward away from the center of the tiller and re-securing the 

pins in the holes provided. See Fig. 6-1.