Husqvarna 1152417-30 用户手册

English

 – 7

•

Keep work area clean and well lit. Cluttered or dark areas 
invite accidents.

•

Do not operate power tools in explosive atmospheres, 
such as in the presence of flammable liquids, gases or 
dust. Power tools create sparks which may ignite the dust 
or fumes.

•

People and animals can distract you causing you to lose 
control of the machine. For this reason, always remain 
concentrated and focused on the task.

•

Do not use the machine in bad weather, such as dense 
fog, heavy rain, strong wind, intense cold, etc. Working in 
bad weather is tiring and can lead to dangerous 
conditions, e.g. slippery surfaces.

•

Never start to work with the machine before the working 
area is clear and you have a firm foothold. Look out for any 
obstacles with unexpected movement. Ensure that no 
material can become loose and fall, causing injury when 
operating the machine.

•

Always check the rear side of the surface where the drill 
bit will emerge when drilling right through. Secure and 
cordon off the area and make sure that no one can be 
injured or material damaged.

•

The machine should be connected to an earthed outlet 
socket.

•

Check that the mains voltage corresponds with that stated 
on the rating plate on the machine.

•

Check that the cord and extension cord are intact and in 
good condition. Use an extension cord intended for 
outdoor use.

•

Never use the machine if any cable or plug is damaged, 
but hand it in to an authorized service workshop for repair.

•

Do not use an extension cord while it is rolled up to avoid 
overheating.

•

Never carry the machine by means of the cord and never 
pull out the plug by pulling the cord.

•

Keep all cords and extension cords away from water, oil 
and sharp edges. Make sure the cord is not pinched in 
doors, fences or the like. Otherwise it can cause the object 
to become live.

•

The water system cools the drill bit with clean water. The 
power tool should not be exposed to more moisture than 
what is provided by the water system. Make sure that no 
drill slurry enters the machine.

•

Do not expose the power tool to rain. Water entering a 
power tool will increase the risk of electric shock.

•

Ensure the cord is behind you when you start to use the 
machine so that the cord will not be damaged.

•

Wear personal protective equipment. See instructions 
under the heading ”Personal protective equipment”.

•

Never use the machine if you are tired, if you have drunk 
alcohol, or if you are taking medication that could affect 
your vision, your judgement or your co-ordination.

•

Prevent unintentional starting. Ensure the switch is in the 
OFF-position before connecting to power source. 
Carrying power tools with your finger on the switch or 
energising power tools that have the switch on invites 
accidents.

•

Remove any adjusting key or wrench before turning the 
power tool on. A wrench or a key left attached to a rotating 
part of the power tool may result in personal injury.

•

Never allow anyone else to use the machine without first 
ensuring that they have understood the contents of the 
operator’s manual.

•

Be careful as clothing, long hair, and jewellery can get 
caught in moving parts.

•

Remain at a distance from the drill bit when the motor is 
running.

•

Make sure that no pipes or electrical cables are routed in 
the area to be drilled.

•

Never leave the machine unsupervised with the motor 
running.

•

Always unplug the machine during longer work breaks.

•

Never work alone, always ensure there is another person 
close at hand. Apart from being able to receive help to 
assemble the machine, you can also get help if an 
accident should occur.