Husqvarna DM 340 用户手册

4 – 

English

It is our wish that you will be satisfied with your product and 
that it will be your companion for a long time. Think of this 
operator

′s manual as a valuable document. By following its′ 

content (using, service, maintenance etc) the life span and 
the second-hand value of the machine can be extended. If 
you will sell this machine, make sure that the buyer will get the 
operator

′s manual.

A purchase of one of our products gives you access to 
professional help with repairs and services. If the retailer who 
sells your machine is not one of our authorised dealers, ask 
him for the address of your nearest service workshop.

Husqvarna Construction Products has a policy of continuous 
product development. Husqvarna reserves the right to modify 
the design and appearance of products without prior notice 
and without further obligation introduce design modifications.

•

DM 340 is an electric stand drill,  intended for drilling holes 
in concrete, bricks and various stone materials.

•

The drilling machine has a modular design and is easy to 
assemble.

•

The machine is equipped with a water connection which 
can be rotated 180 degrees to facilitate work. 

•

DM 340 has three speed ranges for drill bit sizes up to 400 
mm.

•

The machine has a water cooled gearbox with a pipe that 
runs through the spindle.

•

The machine is equipped with LEDs which indicate the 
power output.  This way you can always get maximum 
power output without damaging the machine. 

The drilling machine is equipped with Softstart

TM

, 

Smartstart

TM

, Elgard

TM

 and speed control.

Softstart

TM

 is an electronic current limiter which provides a 

softer start. Maximum speed is reached about three seconds 
after the machine is turned on.

If the Smartstart

TM

 button is pressed in the speed is reduced. 

In Smartstart

TM

 mode the machine has less power until the 

button is pressed in again. These functions are of great use 
for creating a pilot hole for drilling.

Elgard

TM

 is an electronic overload protection. It considers 

factors such as rated input voltage and ambient temperature.   
This way you can always get maximum power output without 
damaging the machine. 

If the motor is overloaded, the overload protection pulses the 
motor. Reduce the load and the motor returns to its normal 
speed. The overload protection disconnects the power, if the 
machine is subjected to heavy loads or if the drill bit jams. 
Reset the machine by switching it off and then on again.  If the 
drill bit jams, the mechanical slip clutch protects the gearbox 
before the overload protection disconnects the power.

The speed control function provides the machine with a 
limited idling speed. This provides a more effective cooling of 
the machine at idle speed. 

The carrying handle makes it easy to carry/transport the 
machine and facilitates mounting it on the stand.