Woodstock D2677 用户手册

-9-

Figure.6..Secure base to floor.

Figure.7..Secure base to 4' x 4' x

3

⁄

4

" plywood.

a. Position the drill press in a sensible work 

area where the base sits flat at all four 

corners, or the base may crack when you 

tighten the fasteners.

b. Mark and drill the floor, and install the 

concrete anchor bolts (not included) (see

Figure.6).

c. Position the base and fasten the base to 

the floor carefully as not to crack it.  

 

a. Center the drill press base along the back 

edge of the 4' x 4' x

3

⁄

4

" sheet of plywood 

(see

Figure.7).

b. At each corner of the drill press base, drill

the plywood.

c. Secure the base to the plywood with four 

3/8" diameter bolts, washers, and nuts

(not included).

a. Position the base on a bench or tool table 

capable of supporting approximately 100

lbs. 

b. Drill two mounting holes (Figure.8), and

secure the base to the table with the two 

supplied carriage bolts and wing nuts

2.. Place the column on the base, and install the 

four column bolts supplied.

For maximum stability, secure the W1670

floor-model drill press to a sturdy surface like 

a floor or a 4' x 4' x

3

⁄

4

" piece of plywood. For 

the W1669 bench-model, secure it to a sturdy

workbench or tool table.

Figure.8..Workbench mounting holes.

Mounting 

Holes