Roland EGX-350 用户手册
56
Chapter 4 Engraving
4-4 Cutter Installation Method 1 (With Nose Unit)
Installing a Character Cutter (With Nose Unit)
WARNING
Never inadvertently touch the computer or handy panel while performing this
task.
task.
Unintended operation of the machine may result in injury.
WARNING
Securely fasten the cutting tool and in place. After securing in place, make sure no
wrenches or other articles have inadvertently been left behind.
wrenches or other articles have inadvertently been left behind.
Otherwise such articles may be thrown from the machine with force, posing a risk of
injury.
injury.
CAUTION
Caution: cutting tool.
The cutting tool is sharp. To avoid injury, exercise caution.
This performs engraving using the nose unit. When the tip of the nose unit touches the surface of the workpiece, the
location is automatically detected as the Z origin point. This makes it possible to perform engraving at a uniform depth
on a workpiece of uneven surface height. This also eliminates the need to set the Z-axis origin point each time when
you’re engraving a number of different workpieces.
location is automatically detected as the Z origin point. This makes it possible to perform engraving at a uniform depth
on a workpiece of uneven surface height. This also eliminates the need to set the Z-axis origin point each time when
you’re engraving a number of different workpieces.
1.
Install the cutter holder, solid collet, and nose unit.
➊
Install the cutter holder.
While holding the spindle unit immobile with
a wrench, tighten the cutter holder.
The cutter holder is reverse-threaded (that is,
you turn it counterclockwise to tighten it). Be
careful to turn it in the correct direction.
a wrench, tighten the cutter holder.
The cutter holder is reverse-threaded (that is,
you turn it counterclockwise to tighten it). Be
careful to turn it in the correct direction.
Cutter holder
Wrench
Spindle unit
Type of cutter used
Nose-unit usage
Suitable workpiece types
Automatic Z-axis control
Spindle rotation
Lock-lever position
Character cutter or flat cutter
Used
Acrylic and other plastic-resin panels
Note: Aluminum, brass, and other easily scratched workpieces are not
suitable.
Note: Aluminum, brass, and other easily scratched workpieces are not
suitable.
On
On
or
Cutter holder
Hexagonal
screwdriver
screwdriver
Loose