Schumacher 92035 用户手册

 

The following safety information is provided as a guideline to help you operate your new cutter under 
the safest possible conditions. Any equipment that uses electrical power can be potentially dangerous 
to use when safety or safe handling instructions are not known or not followed. The following safety 
information is provided to give you the information necessary for safe use and operation. 

When a WARNING precedes a procedure step, it is an indication that the step contains a procedure 
that might be injurious to a person if proper safety precautions are not heeded. When a procedure 
step is preceded by a CAUTION, it is an indication that the step contains a procedure that might 
damage the equipment being used. A NOTE may be used before or after a procedure step to highlight 
or explain something in that step. 

READ ALL SAFETY INSTRUCTIONS CAREFULLY before attempting to install, operate, or service 
this cutter. Failure to comply with these instructions could result in personal injury and/or property 
damage. 

Published standards on safety are available. They are listed in ADDITIONAL SAFETY 
INFORMATION at the end of this SAFETY SUMMARY. The National Electrical Code, Occupational 
Safety and Health Act regulations, local industrial codes and local inspection requirements also 
provide a basis for equipment installation, use, and service. 

Electric shock can kill! To reduce the risk of death or serious injury from shock, read, 
understand, and follow the following safety instructions. In addition, make certain that 
anyone else who uses this welding equipment, or who is a bystander in the cutting 
area understands and follows these safety instructions as well. 

IMPORTANT! TO REDUCE THE RISK OF DEATH, INJURY, OR PROPERTY 
DAMAGE, DO NOT ATTEMPT OPERATION of this cutting equipment until you have 

read and understand the following safety summary. 

•  Do not, in any way, come into physical contact with any part of the plasma cutter electrical 

circuit, including the work piece or any conductive material in contact with it, the ground 
clamp, or any metal parts on the torch. 

•  Do not cut in a damp area or come in contact with a moist or wet surface. 
•  Do not attempt to cut if any part of clothing or body is wet. 
•  Do not allow the cutting equipment to come in contact with water or moisture. 
•  Do not drag cables, plasma torch, or power cord through or allow them to come into contact 

with water or moisture. 

•  Do not touch cutter, attempt to turn cutteron or off if any part of the body or clothing is moist or 

if you are in physical contact with water or moisture. 

•  Do not attempt to plug the cutter into the power source if any part of body or clothing is moist, 

or if you are in physical contact with water or moisture. 

•  Do not connect cutter ground clamp to or cut on electrical conduit. 
•  Do not alter power cord or power cord plug in any way. 
•  Do not attempt to plug the cutter into the power source if the ground prong on power cord 

plug is bent over, broken off, or missing. 

•  Do not allow the cutter to be connected to the power source or attempt to cut if the cutter,  

cables, cutting site, or  power cord are exposed to any form of atmospheric precipitation, or 
salt water spray. 

•  Do not carry coiled cables around shoulders, or any other part of the body, when they are 

plugged into the cutter. 

 

 

2