Konica Minolta 2450 用户手册
Solving Problems with Media Misfeeds
114
Solving Problems with Media Misfeeds
"
Frequent misfeeds in any area indicate that area should be checked,
repaired, or cleaned. Repeated misfeeds may also happen if you’re
using unsupported print media.
repaired, or cleaned. Repeated misfeeds may also happen if you’re
using unsupported print media.
Symptom
Cause
Solution
Several
sheets go
through the
printer
together.
sheets go
through the
printer
together.
The front edges of
the media are not
even.
the media are not
even.
Remove the media and even up the
front edges, then reload it.
front edges, then reload it.
The media is moist
from humidity.
from humidity.
Remove the moist media and replace it
with new, dry media.
with new, dry media.
Too much static elec-
tricity is present.
tricity is present.
Do not fan transparencies.
Media mis-
feed mes-
sage stays
on.
feed mes-
sage stays
on.
Top cover needs to
be opened and
closed again to reset
the printer.
be opened and
closed again to reset
the printer.
Open and close the top cover of the
printer again.
printer again.
Some media remains
misfed in the printer.
misfed in the printer.
Recheck the media path and make
sure that you have removed all of the
misfed media.
sure that you have removed all of the
misfed media.
Duplex
option mis-
feeds.
option mis-
feeds.
Unsupported media
(wrong size, thick-
ness, type, etc.) is
being used.
(wrong size, thick-
ness, type, etc.) is
being used.
Use KONICA MINOLTA-approved
media. See “Media Specifications” on
page 52.
Plain paper, recycled paper, and letter
head can be autoduplexed if the
duplex option is installed and the
media type is set properly in the driver.
See “Media Specifications” on page
52.
Make sure that you have not mixed
media types in Tray 1.
Do not duplex envelopes, labels, trans-
parencies, thick stock, postcard, or
glossy stock.
media. See “Media Specifications” on
page 52.
Plain paper, recycled paper, and letter
head can be autoduplexed if the
duplex option is installed and the
media type is set properly in the driver.
See “Media Specifications” on page
52.
Make sure that you have not mixed
media types in Tray 1.
Do not duplex envelopes, labels, trans-
parencies, thick stock, postcard, or
glossy stock.
Media is still being
misfed.
misfed.
Recheck the media path inside the
duplex option and make sure that you
have removed all of the misfed media.
duplex option and make sure that you
have removed all of the misfed media.