Ricoh Type 8000 用户手册

Sending Scan Files to Folders

40

This section describes the preparations and settings for sending scan files by
Scan to Folder.

❒ Files can be sent to shared folders on client computers.
❒ Files can also be sent to FTP servers if any exist on the network.
❒ Files can also be sent to NetWare servers if any exist on the network.

A

Connect the machine to the network.
Connect the machine to the network using an Ethernet or wireless LAN (IEEE
802.11b).

B

Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask.
• Specify the IPv4 gateway address.
• In [Effective Protocol], enable [IPv4].
• To send files to shared folders, enable [SMB] in [Effective Protocol]. To send

files to NetWare folders, enable [NetWare] in [Effective Protocol].

C

❒ To connect the machine to the network using a wireless LAN (IEEE

802.11b), an extended wireless LAN board is required respectively. For de-
tails, see Network Guide.

❒ Items to set up in [System Settings] vary depending on the network environ-

ment. For more information about network settings, see General Settings
Guide.

❒ For details about [Scanner Features], see General Settings Guide.
❒ Sending files using SMB is available only under a NetBIOS over TCP/IP

environment. Sending files using SMB is not available under a NetBEUI
environment.

❒ Even when settings made with the control panel, Web Image Monitor, Tel-

net, or other methods do not permit the use of SMB and FTP, sending files
is still possible.