Sharp MXC250 用户手册

This function works in Auto Power Shut-Off mode. 
When the machine completes a print job received from 
the PC or outputs received fax data, the machine 
immediately returns to the Auto Power Shut-Off mode.

You can reduce the amount of toner used for 
copying/printing.

This is used to print lists and reports that are only for 
use by the administrator of the machine.
Select the [List Print] to configure the settings.

This is used to perform automatic color correction 
when the color in color copies is off. The machine 
prints a test patch, the test patch is scanned, and the 
color is automatically corrected.

After the [OK] is selected and a test patch is printed, a 
message appears prompting you to begin automatic 
calibration. Place the test patch on the document glass 
as shown below (so that the light patch at the edge of 
the page is to the left).

Align the upper left corner of the original with the mark.

Lay copy paper (about five sheets) that is the same 
size as the test patch on top of the placed test patch, 
gently close the automatic document feeder, and 
select the [OK].

Toner Save Mode (Print) is only effective 
when the machine's printer driver is not 
used. When the printer driver is used, the 
printer driver setting takes precedence. 
This function may not operate in some 
applications and operating systems.

Fax Settings

Shows the current state of the 
system settings, as well as the 
sender name, sender number, 
polling passcode numbers, and 
forwarding numbers.

Inbound  
Routing

Shows the inbound routing settings 
for routing received faxes on your 
network.

User Usage List

Shows the communication time and 
number of pages transmitted by each 
user.

Activity Report

Shows a log of past communication 
performed on the machine (date of 
communication, name of other party, 
time required, result, etc.).

Junk Fax # List

Shows the stored fax numbers from 
which reception in "Anti Junk Fax" 
(p.188) is blocked.

User Info. Print

The user name, user number, paper 
used, paper limits, and function 
permission settings can be printed 
for each user.
*Cannot be printed if no users are 
registered.

• Before executing Auto Color Calibration, 

check to see if the registration adjustment 
is correct. If the registration adjustment is 
not correct, perform "Registration 
Adjustment" (p.179).

• If the color is still off after performing Auto 

Color Calibration, repeating Auto Color 
Calibration once again may improve the 
color.

Align the upper left corner of the original 
with the 

 mark.