Samsung CLX-318X 用户手册

Getting started_ 1

1.

getting started

This chapter gives you step-by-step instructions for setting up the USB connected machine and software.

•

•

•

•

•

  

•

Supported optional devices and features may differ according to your 

model. Check your model name. 

•

Illustrations may differ from your machine depending on the model or 

its options. Check your model name.

This section shows the steps to set up the hardware, as is explained in the 

Quick Installation Guide. Make sure you read the Quick Installation Guide 

first and follow the steps below.
1. Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow 

extra space to open door(s) and tray(s). 
The area should be well ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft.). Refer to the 

altitude setting to optimize your printing (See "Altitude adjustment" on 

page 1).
Place the machine on a flat, stable surface so that there is no incline 

greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected.

2. Unpack the machine and check all the enclosed items.
3. Remove all tape.
4. Install the toner cartridge.
5. Load paper (See "Loading paper in the tray" on page 4).
6. Make sure that all cables are connected to the machine. 
7. Turn the machine on.

When you move the machine, do not tilt or turn it upside down. 

Otherwise, the inside of the machine may be contaminated by toner, 

which can cause damage to the machine or bad print quality.
This machine will not operate when the power main fails.

•

Installed software may be different depending on each model.