Xerox FS 5250 用户手册

 to the Printer

Connecting the Xerox FS 5250  to the printer is done by following these
steps:

1.

Check that the printer's parallel input port is available on printer.

2.

Connect the cable supplied with the Xerox FS 5250 between the
printer's parallel input port and the protocol converter's PARALLEL
OUT port.

3.

Power on the printer and the Xerox FS 5250.

4.

Turn the address switch (on the rear panel) to the "T" position . A
settings printout is generated and the  CU indicator starts flashing.

The interface can be set up in many ways. Upon delivery the interface
is set up to cover most needs and uses. Appendix B  "Test Printout" is
a sample printout of settings and is but one way of setting up your
interface.

Keep the settings printout you make together with this manual for 
future reference.

If the printout format does not match the test printout in Appendix B
"Test Printout", or if nothing was printed, this means that the printer
setup does not match the protocol converter setup. Contact your
systems support personnel or your point of purchase for assistance.

5.

When the printout is in order, you proceed to the following section
"Connecting the Xerox FS 5250 to the System".