Xerox FS 5250 用户手册
Function Selection via the Line
Xerox FS 5250, User’s Guide
Xerox FS 5250, User’s Guide
- 29 -
8.3. Defining a Temporary Escape Character
No escape character is defined when you receive the printer. If you wish to
change the settings of the printer from the host system, you will have to
define the escape character. See below how to define "%" as the tem porary
escape character.
change the settings of the printer from the host system, you will have to
define the escape character. See below how to define "%" as the tem porary
escape character.
NOTE:
The characters "," ";" and ":" must never be used as escape charac
The characters "," ";" and ":" must never be used as escape charac
ters,
as they are used as separators in escape sequences and will be ig-
nored by the printer.
The same applies to 0-9, A-F, a-f and K,S,T,X,Y,Z, simple quote ('), &
and ?. These must not be used.
nored by the printer.
The same applies to 0-9, A-F, a-f and K,S,T,X,Y,Z, simple quote ('), &
and ?. These must not be used.
CAUTION!
Avoid using your national characters as ESC characters.
The following EBCDIC HEX codes have been defined as national
language characters and must not be used as ESC characters
language characters and must not be used as ESC characters
4A 4C 4F 5A 5B 5F 6A 79 7B 7C 7F A1 C0 D0 E0
&&??%
Defining a temporary escape character.
The five characters shown should be sent to the printer from the host
system. The escape character is not defined perma nently. When the
converter is turned off, it will be lost. See "Defining a Permanent Escape
Character" for infor mation on the definition of a permanent escape character.
system. The escape character is not defined perma nently. When the
converter is turned off, it will be lost. See "Defining a Permanent Escape
Character" for infor mation on the definition of a permanent escape character.
8.4. Removing Temporary Escape Character
If you wish to remove the temporary escape character so that it may be used
as a printable character , you can define it as a blank as shown below.
as a printable character , you can define it as a blank as shown below.
&&??<blank>
Removing the temporary escape character.