Xerox 7232 用户手册

This section describes the installation procedure for using the machine on an SMB 
network.

The installation procedure is as follows.

Enable the SMB port.

•

If using TCP/IP, set the SMB port to [Enabled] using the touch screen or CentreWare 
Internet Services. Set the IP address on the control panel or CentreWare Internet 
Services.

Install the print driver on the computer.

A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This procedure is used to set up the network communication parameters of the 
machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from the 
CentreWare Internet Services. 

Initially, boot the SMB port.

Connect the machine to the network.

Press the <Log In/Out> button on the control panel, and then type the Key 
Operator login ID to enter the Key Operator mode. 

NOTE: The passcode may also be required depending on the machine configuration.

Press the <Machine Status> button on the control panel, and then select the 
[Tools] tab on the screen. 

Select [System Settings].

Select [Connectivity & Network Setup].