Xerox 7232 用户手册

This requires the workstations in the networking environment to be configured to 
communicate with the machine.

A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This section describes how to set up the network communication parameters of the 
machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from 
CentreWare Internet Services. 

Initially, boot the LPD port or Port9100.

Connect the machine to the network.

Press the <Log In/Out> button on the control panel, and then type the Key 
Operator login ID to enter the Key Operator mode. 

NOTE: The passcode may also be required depending on the machine configuration.

Press the <Machine Status> button on the control panel, and then select the 
[Tools] tab on the screen. 

Select [System Settings].

Select [Connectivity & Network Setup].

Select [Port Settings].

If you are using the LPD port, select [LPD] and [Change Settings]. If you are using 
Port9100, select [Port9100] and [Change Settings].

If you are using the LPD port, select [Port Status] and [Change Settings]. If you 
are using Port9100, select [Port Status] and [Change Settings].

Select [Enabled] and [Save].

Next, establish TCP/IP.

In [Connectivity & Network Setup], select [Protocol Settings].

Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].

Select [IP Address Resolution], and then [Change Settings].