Xerox 7232 用户手册

This section describes how to set up the network communication parameters of the 
machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from the 
CentreWare Internet Services. 

Initially, enable the IPP port.

Connect the machine to the network.

Press the <Log In/Out> button on the control panel, and then type the Key 
Operator login ID to enter the Key Operator mode. 

NOTE: The passcode may also be required depending on the machine configuration.

Press the <Machine Status> button on the control panel, and then select the 
[Tools] tab on the screen. 

Select [System Settings].

Select [Connectivity & Network Setup].

Select [Port Settings].

Select [IPP], and then [Change Settings].

Select [Port Status], and then [Change Settings].

Select [Enabled], and then [Save].

Next, establish TCP/IP.

In [Connectivity & Network Setup], select [Protocol Settings].

Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].

Select [IP Address Resolution], and then [Change Settings].

Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], 
[DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server 
(WINS) server.

If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol 
settings. Otherwise, proceed to step 11.

Select [IPv4 - IP Address], and then [Change Settings].