Xerox 7232 用户手册

Network scanning uses the FTP or SMB protocol to transfer scanned documents on to 
a server or a client. Templates and repositories (folders) need to be set up to enable 
network scanning. 

See the Quick Network Setup Guide for information about how to set up templates, 
repositories, transfer prococols, and enabling ports. 

Confirm that an existing operational network utilizing TCP/IP is available.

Confirm that your transfer protocol (FTP/SMB) is configured correctly.

For more details, refer to Scan to PC Setup (FTP) on page 147 or Scan to PC 
Setup (SMB) on page 148.

Repository (folder) needs to be created on the FTP or SMB server to hold 
scanned documents.

Confirm that the following ports are enabled:

1) TCP/IP Port

2) FTP Client Port or SMB Port (depending on which protocol is used)

Create templates and repositories via CentreWare Internet Services.

On the control panel, select [Network Scanning].

Select a template from the list. You can also change any other value from the 
control panel without impacting the template configuration; only the current job will 
be affected.

Load a sample document into the document feeder.

Press the green <Start> button on the machine. The job is sent to the server using 
FTP or SMB protocol as defined within the template.

Templates are created via CentreWare 
Internet Services or any other Xerox 
Network Scanning Solutions.

Required

Repositories are created via CentreWare 
Internet Services or any other Xerox 
Network Scanning Solutions.

Required

Kerberos IP Address

Optional

If Remote Authentication is required, 
then Kerberos needs to be enabled.