Xerox D60327 用户手册
Appendix Section
Xerox 4500 PS TR
Xerox 4500 PS TR
158
Appendix A: Configuration Using Setup File
Appendix A 1: Configuring via parallel port
The default LAN and TCP/IP parameters may be set up via the parallel port.
If this method is used instead of using the configuration file, then the IP
default (IP address gateway and subnet mask) must be specified in the
configuration file when the Xerox 4500 PS TR is set up for the first time.
default (IP address gateway and subnet mask) must be specified in the
configuration file when the Xerox 4500 PS TR is set up for the first time.
The configuration file must be sent via the centronics port.
NOTE:
On OS/2 workstations use IBMNULL as printer driver
On DOS or Windows use a Generic /Text printer driver only.
On OS/2 workstations use IBMNULL as printer driver
On DOS or Windows use a Generic /Text printer driver only.
1. Select the file you wish to send to the parallel port.
2. In this file you write the following command sequence at the top of the file:
&&??##N1,0#<CR>
3. Type: END
4. To send the file, you write the following at the command prompt.
copy <filename> <lpt1>
where lpt1 is the PC’s centronics port.
5. For the settings to become effective you must either:
- turn the Xerox 4500 PS TR off and on
or
- define the Xerox 4500 PS TR to boot from the configuration file
or
- define the Xerox 4500 PS TR to boot from the configuration file
Type:
BEGIN_CONFIGURATION IDAPS
BEGIN_CONFIGURATION IDAPS
BOOT
END
6. Make a settings printout to verify the new settings.
You should only modify or change the settings via the bootfile for strictly necessary
purposes.
Otherwise, you are recommended to use e.g.Telnet. (see the chapter on Configuration)
purposes.
Otherwise, you are recommended to use e.g.Telnet. (see the chapter on Configuration)