Xerox D60327 用户手册

The Xerox 4500 PS TR supports an online microcode upgrade facility
permitting the installation of revised product microcode.

Operation of this facility will be possible in the following ways:

1.

Via the TCP/IP boot server

2.

Via the centronics port

• 

• 

During the initial 20-30 seconds after the microcode
download, a failure (power off) will have fatal consequences,
because the code will be lost and the previously stored code
erased. If this happens, a basic code still remains in the
flash to allow redownload of code. But download can then
only take place via the parallel port.

 

 

• 

• 

You must always connect printer to PARALLEL port.

The Xerox 4500 PS TR microcode can be upgraded via the PAR1 port by
using a PC containing the microcode in the form of a file.

To download the microcode via the parallel port follow these guidelines:

1. Power printer off.
 
2. Connect a PC to the parallel port using a centronics cable.
 
3. Power up the printer. When the session LED is lit, press the TEST key

shortly.

 

4. When the printer generate a test page with the message: “xxx | 5108

Awaiting microcode download”, the  Xerox 4500 PS TR is ready for
microcode download.

 

5. Type the following command at the PC's command-prompt :

 

 

"copy 0xxxxx.B80 lpt1 /b 

"

 

 

where "0xxxxx.B80" is an example of a firmware file.

1

                                            

1

 The suffix .B80 may be case sensitive depending on the operating system.