Xerox 5230A 用户手册

UNIX TCP/IP 

241

The machine uses the Line Printer Daemon Protocol (LPD) that supports TCP/IP as the 
transport protocol. With the LPD, use the machine as a UNIX network printer.
The LPD supports spool mode, this is where print jobs from clients are spooled once 
before output. It also supports non-spool mode, this is where print jobs are output 
sequentially, without spooling.

The target computers are as follows.

• Workstation or personal computer with RFC 1179 Line Printer Daemon Protocol

The LPD is available on the following interfaces:

• Ethernet 100Base-TX

• Ethernet 10Base-T
The applicable frame types conform to Ethernet II (Ethernet interface).

This section explains how to install the machine in a UNIX TCP/IP environment.

There are three stages.

Network Communication Setup
The machine needs to be set up and configured for TCP/IP.

Computer Setup
The computer OS needs to be configured for the machine.

Test Print
A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

Use this procedure to set up the network communication parameters of the machine.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: Some of the configuration options for this protocol are only available from 
CentreWare Internet Services. Refer to 

Follow the steps below to establish TCP/IP.

Connect the machine to the network.