Xerox 5230A 用户手册

8 Printer Environment Settings 

248

This section describes printing from workstations running Solaris or HP-UX. Refer to 
the manuals supplied with the workstation for full details.

Print (lp)
The lp command is used for printing.

lp [-d printer name] [-n number of copies] File name

Command options
The following command options are available.

• -d printer name

Specify the printer name registered by the lpadmin command as the -d option. If this 
option is omitted, the default printer lp will be used.

• -n number of copies

This option specifies the number of copies. If one lp command is issued to print multiple 
files, the number of copies specified will apply to all the files. However, this is only 
effective when the machine is in the spool mode. In the non-spool mode, the client must 
be a Windows NT machine to use this option.
NOTE: Some options which are not listed here (e.g. -m option) and which are not 
processed by the workstation sending the print instructions, will not be valid.

NOTE: In the spool mode, up to 32 files can be printed by one lp command. Any files 
specified after the 32nd file will be ignored.

Example
To print a file named file1 to a printer named fxPS, enter the following command:

%lp -dfxPS file1

To output three copies of file1 and then three copies of file 2 to fxPS, enter the following 
command:

%lp -dfxPS -n3 file1 file2

Delete (cancel)
The cancel command is used to delete print data.

cancel [printer name] [job number]

Command options
The following command options are available.

• Printer name

This option specifies the printer name. The cancel command can be effectively used 
with the combined use of -a, -e and -u as shown below. This option is only valid in the 
spool mode.