Xerox 5790 用户手册

下载
页码 50
XEROX WorkCentre 
5735/5740/5745/5755/5765/5775/5790 
Information Assurance Disclosure Paper 
 
 
Ver. 2.00, March 2011 
        
Page  16 of 50 
 
Figure 2-6  IPv6 Network Protocol Stack 
 
2.8.  Logical Access 
2.8.1. Network Protocols 
The supported network protocols are listed in Appendix D and are implemented to industry standard specifications 
(i.e. they are compliant to the appropriate RFC) and are well-behaved protocols.  There are no ‘Xerox unique’ 
additions to these protocols. 
2.8.1.1. 
IPSec 
The device supports IPSec tunnel mode.  The print channel can be secured by establishing an IPSec association 
between a client and the device.  A shared secret is used to encrypt the traffic flowing through this tunnel.  SSL must 
be enabled in order to set up the shared secret. 
When an IPSec tunnel is established between a client and the machine, the tunnel will also be active for 
administration with SNMPv2 tools (HP Open View, etc.), providing security for SNMP SETs and GETS with an 
otherwise insecure protocol.  SNMP Traps may not be secure if either the client or the device has just been rebooted.  
IP Filtering can be useful to prevent SNMP calls from non-IPSec clients. 
Once an IPSec channel is established between two points, it stays open until one end reboots or goes into power 
saver,.  Only network clients and servers will have the ability to establish an IPSec tunnel with the machine.  Thus