Xerox a2 用户手册
DOCUCOLOR 12 SYSTEM ADMINISTRATION GUIDE
4–19
MAINTENANCE
1
2
3
4
5
6
7
Replacing the Fuser Oil Cartridge
When a message is displayed to replace the
Fuser Oil, follow the instructions provided on this
page in addition to those on the labels
surrounding the Fuser Oil area (Figure 34) and
affixed to the copier/printer.
Fuser Oil, follow the instructions provided on this
page in addition to those on the labels
surrounding the Fuser Oil area (Figure 34) and
affixed to the copier/printer.
WARNING: The fuser can be very hot. To avoid
personal injury, do not touch any component other
than those indicated in the following procedure.
personal injury, do not touch any component other
than those indicated in the following procedure.
CAUTION:Fuser oil can be slippery. If any fuser
oil is spilled on the floor, thoroughly clean the
area.
oil is spilled on the floor, thoroughly clean the
area.
WARNING: Do not place the fuser oil cartridge on
the copier/printer. If any fuser oil is spilled on the
copier/printer, thoroughly clean it.
the copier/printer. If any fuser oil is spilled on the
copier/printer, thoroughly clean it.
WARNING: Fuser oil may cause irritation to your
eyes. Thoroughly wash your hands with soap and
water after handling the fuser oil cartridge.
eyes. Thoroughly wash your hands with soap and
water after handling the fuser oil cartridge.
1
Open the Front Door of the copier/printer.
2
Place a few sheets of paper on the floor to catch
any fuser oil that may spill.
any fuser oil that may spill.
3
Rotate the green handle clockwise, to the down
position.
position.
Figure 34: Check the Fuser Oil message