Xerox 490 ST 用户手册
Page 3 - 6
Xerox Document Centre System Administration Guide
Static Addressing
NOTE
Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If you have a DHCP server and
it is set to provide host name, IP address, Gateway address, and
Subnet Mask, the Document Centre TCP/IP information will be
configured on initial boot. This procedure assumes you will set the
IP information manually.
the IP protocol enabled by default. If you have a DHCP server and
it is set to provide host name, IP address, Gateway address, and
Subnet Mask, the Document Centre TCP/IP information will be
configured on initial boot. This procedure assumes you will set the
IP information manually.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
For information on how your printer can connect to a DHCP,
BOOTP, or a RARP server to be assigned an IP address
dynamically, refer to the section in this chapter entitled Dynamic
Addressing (DHCP, BOOTP, or RARP).
BOOTP, or a RARP server to be assigned an IP address
dynamically, refer to the section in this chapter entitled Dynamic
Addressing (DHCP, BOOTP, or RARP).