Xerox 701P42722_EN 用户手册

This section describes how to set up USB communication on the machine. The 
following parameters can be set depending on your requirements. These setups must 
be done without the USB cable connected.

Enable the USB port.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to CentreWare Internet Services chapter on page 91.

Press the <Log In/Out> button.

Select [System Settings].

Enter the password using the numeric keypad and then select [Confirm].

Select [Print Settings] and then press the <Enter> button.

Press the <Enter> button on the [Network/Port] screen.

Select [USB] by selecting  [

T] or [S] and then press the <Enter> button.

Select [Port Status] by selecting  [

T] or [S] and then press the <Enter> button.

Select [Enable] by selecting  [

T] or [S] and then press the <Enter> button.

If necessary, you may change the following settings.

•

Auto Eject Time

•

Print Mode

•

PJL

•

Adobe Protocol

NOTE: Adobe Protocol can be set when the PostScript Kit (optional) has been 
installed.

Press the <Log In/Out> button.

Before starting Workstation Setup, make sure that the USB cable is disconnected from 
the computer.

Then perform the following steps.

Refer to the HTML documentation in CentreWare Utilities CD-ROM or 
documentation provided with the optional PostScript Kit, and install the print 
drivers for the machine on all the workstations that will be sending jobs to the 
machine.

Continue with Test Print on page 84.