Xerox 3535 用户手册

5 – 6

Xerox DocuColor 3535 Printer/Copier

Transparencies can be fed from Trays 1- 5 (Bypass). Stripeless 
transparencies are recommended. Striped transparencies must 
be loaded in Trays 1 - 4 with the stripe face down, on the right side 
of the tray. For Tray 5 (Bypass) striped transparencies must be 
loaded with the stripe face up, on the left side of the tray.

Recommended Materials for the DocuColor Series. 

After loading the transparencies you can program the copier 
printer to insert a blank separator page between transparencies by 
using the Transparency Separators feature. 

For more information about the Tranparency Separators feature, 
refer to the section entitled Transparency Separators, in this 
chapter.

Follow these guidelines to prevent static build up when using 
transparencies:

•

Place no more than twenty 8.5x11 inch or A4 transparencies in 
Tray 5 (Bypass) at one time.

•

Place only one 11x17 in. or A3 transparency in Tray 5 
(Bypass) at a time.

•

Remove the transparencies from the Center Output Tray 
before running additional sets.

•

It is not recommended that you output more than 20 
transparencies at a time. If your job is larger than 20 pages, 
use the Transparency Separators feature.

For more specific information about materials that have been 
tested and approved for use in the DocuColor 3535, refer to the 
Recommended Materials for the DocuColor Series. Current 
information is also available at the Xerox web site.