Xerox 8510 用户指南
Adjusting Copying Options
Phaser® 8510/8560MFP Multifunction Product
4-9
Using the Prescan Glass Option
When using the document glass, you can prescan originals when using the auto center, edge
erase, auto reduce/enlarge, and poster options.
erase, auto reduce/enlarge, and poster options.
To select a prescan setting:
1.
On the control panel, press the Copy button.
2.
Select
Prescan Glass
, and then press the OK button.
3.
Select one of the following options:
■
Off
: Turns off prescanning. Select an original size for your copy.
■
On
: Turns on prescanning when any of the auto center, edge erase, auto
reduce/enlarge, and poster options are turned on. When all these options are turned
off, the copy area is calculated based on the current paper supply size.
off, the copy area is calculated based on the current paper supply size.
Note:
The book copy option always prescans.
See also:
Reducing or Enlarging the Image
You can reduce the image to 25% of its original size or enlarge it to 400% of its original size.
To use reduce or enlarge the image:
1.
On the control panel, press the Copy button.
2.
Select one of the following options:
■
Select
Preset
Reduce/Enlarge
, and then press the OK button. A list of preset values
appears from which you can select the size of the original followed by the size of the
copy paper.
copy paper.
■
Press the Reduce/Enlarge cascade button on the control panel to select these options:
■
Auto
: Reduces or enlarges the image as needed to fit the full size of the copy
paper.
■
25%-400%
: Reduces or enlarges the image by a selected percentage: 25, 50, 100,
150, 200, and 400.
■
Press the up or down button below the three-digit LED to reduce or enlarge the
copy size in increments of one percent. 100% keeps the copy image the same size
as the original.
copy size in increments of one percent. 100% keeps the copy image the same size
as the original.
Note:
The factory default is 100%.