Xerox 8510 用户指南
Overview of Network Setup and Configuration
Phaser® 8510/8560MFP Multifunction Product
2-2
Overview of Network Setup and Configuration
To set up and configure the network:
1.
Turn on the system and the computer.
2.
Connect the system to the network using the recommended hardware and cables.
3.
Configure the system’s network address, which is required to identify the system on the
network.
network.
■
Windows operating systems: Run the Installer on the Software and Documentation
CD-ROM to automatically set the system’s IP address if the system is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel. Once the IP address is set, continue the installation procedure to install
the driver software.
CD-ROM to automatically set the system’s IP address if the system is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel. Once the IP address is set, continue the installation procedure to install
the driver software.
■
Macintosh systems: Manually set the system’s network address (for TCP/IP) on the
control panel. Install the driver software on the computer from the Software and
Documentation CD-ROM.
control panel. Install the driver software on the computer from the Software and
Documentation CD-ROM.
Note:
For information on driver installation, see the section in this chapter for the specific
operating system you are using.
If the Software and Documentation CD-ROM is not available, you can download the latest
driver from
driver from
.
See also:
Advanced Features Guide at