Xerox 7435 用户手册
Network Management
WorkCentre 7425/7428/7435
System Administrator Guide
System Administrator Guide
52
Microsoft (NetBIOS over IP) Networks
Before You Start
1. Print a Configuration Report. See
2. Referring to the report, verify that SMB is enabled. To enable SMB at the printer, if required, follow
the procedure below.
3. Referring to the Configuration Report, verify that DNS is enabled. The use of Naming Servers is
required to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
network.
4. To enable the printer to communicate with the Naming Servers, see
5. When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling SMB Setting at the Printer
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. When the Port Settings menu displays, press the SMB selection line.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the SMB selection menu displays, note that you have only one setting available on a single,
4. Touch the Tools tab.
5. Press Connectivity & Network Setup.
6. Press Port Settings.
7. When the Port Settings menu displays, press the SMB selection line.
8. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
9. When the SMB selection menu displays, note that you have only one setting available on a single,
numbered horizontal line. Press this selection line.
10. Press the Change Settings button.
11. On the SMB Port Status screen, note which of the two buttons is highlighted as the current setting
11. On the SMB Port Status screen, note which of the two buttons is highlighted as the current setting
for SMB Enablement. The available settings are Enabled or Disabled. To enable SMB at the printer,
select the Enabled setting.
select the Enabled setting.
12. Press the Save button on the touch screen, which returns you to the SMB selection menu. (To exit
the screen, without making changes, press the Cancel button.)
13. Exit the SMB selection menu and return to the Port Settings menu by pressing the Close button in
the upper right corner of the touch screen.
14. Exit the Port Settings menu by pressing the Close button in the upper right corner of the Port
Settings menu screen.
15. To exit the Tools screen, wait several seconds for the Auto Clear service to log you out.