Xerox FS 5250 IPC 用户手册
Connections and Installation
Xerox FS 5250, User’s Guide
Xerox FS 5250, User’s Guide
- 13 -
6. Connections and Installation of
the Xerox FS 5250
the Xerox FS 5250
This chapter starts with an overview of the functionality of the rear panel.
Then follows a description of how you connect the Xerox FS 5250 box to a
printer and finally how to connect it to a System.
Then follows a description of how you connect the Xerox FS 5250 box to a
printer and finally how to connect it to a System.
NOTE:
Before you start the installation, make sure that you set the address
switch and the desired emulation. See the description in the section
"Emulation".
Before you start the installation, make sure that you set the address
switch and the desired emulation. See the description in the section
"Emulation".
6.1. The Rear Panel
RS232
12-18 VDC.
0.7A
PARALLEL IN
PARALLEL OUT
ADDR
+
--
B
A T 6
5
4
3
2
0
1
A = PCL, B = XES
Xerox FS 5250 Rear Panel
PARALLEL OUT
The parallel output port can be connected to the parallel/Centronics in put
port on the target printer (parallel out cable is supplied with the kit).
The parallel output port can be connected to the parallel/Centronics in put
port on the target printer (parallel out cable is supplied with the kit).
PARALLEL IN
The parallel input port can be connected to the parallel/Centronics out put on
a PC or similar source which enables it to share the printer with the host. For
this connection you need a cable ending in a 25-pole D-Sub connector
(order no. 999022 030).
The parallel input port can be connected to the parallel/Centronics out put on
a PC or similar source which enables it to share the printer with the host. For
this connection you need a cable ending in a 25-pole D-Sub connector
(order no. 999022 030).
SERIAL IN/OUT
The serial port can be configured either as input or as output. Default
configuration is input.
The serial port can be configured either as input or as output. Default
configuration is input.