Xerox 2045e 用户手册

23

This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.

Reference
Before turning the main power off, see ‘Turning On the Power’, General Set-
tings Guide.

❖

❖

❖

❖ Status messages

❖

❖

❖

❖ Alert messages

Hex Dump Mode

In Hex Dump mode, the machine receives data in hexadecimal 
format. Turn off the machine after printing, and then turn back 
on.

Offline

The machine is offline. To start printing, switch the machine 
online by pressing [Offline] on the display panel.

Please wait.

The machine is preparing the development unit. Wait a while.

Printing...

The machine is printing. Wait a while.

Ready

This is the default ready message. The machine is ready for 
use. No action is required.

Resetting job...

The machine is resetting the print job. Wait until “Ready” ap-
pears on the display panel.

Waiting...

The machine is waiting for the next data to print. Wait a while.

Cannot connect with the 
wireless card.

The IEEE 802.11b card may 
have come off, or an error may 
have occurred in the IEEE 
802.11b card.

Turn off the main power 
switch, and check the card is 
installed correctly. If the mes-
sage appears again, contact 
your sales or service repre-
sentative.

Close duplex unit cover.

The cover of the duplex unit is 
open.

Close the cover of the duplex 
unit.

Collate has been cancelled.

The collate print function has 
been canceled.

Turn off the main power 
switch, and back on again. If 
the message appears again, 
contact your sales or service 
representative.