Motorola LS9203 用户手册
Symbol LS9203 Product Reference Guide
2-6
Beeper Definitions
The scanner communicates with the user by emitting different beeper sequences and patterns. Table 2-1 defines beep sequences that
occur during both normal scanning and while programming the scanner.
occur during both normal scanning and while programming the scanner.
Table 2-1. Standard Beeper Definitions
Beeper Sequence
Indication
Standard Use
3 short high beeps
Power up.
Short high beep
A bar code symbol was decoded (if decode beeper is enabled).
4 long low beeps
A transmission error was detected in a scanned symbol. The data is ignored. This occurs if a unit is not
properly configured. Check option setting.
properly configured. Check option setting.
5 low beeps
Conversion or format error.
Lo/hi/lo beep
ADF transmit error.
Hi/hi/hi/lo beep
RS-232 receive error.
Parameter Menu Scanning
Short high beep
Correct entry scanned or correct menu sequence performed.
Lo/hi beep
Input error, incorrect bar code or “Cancel” scanned, wrong entry, incorrect bar code programming
sequence; remain in program mode.
sequence; remain in program mode.
Hi/lo beep
Keyboard parameter selected. Enter value using bar code keypad.
Hi/lo/hi/lo beep
Successful program exit with change in the parameter setting.
Low/hi/low/hi beep
Out of host parameter storage space. Scan
Code 39 Buffering
Hi/lo beep
New Code 39 data was entered into the buffer.
3 long high beeps
Code 39 buffer is full.
Lo/hi/lo beep
The Code 39 buffer was erased or there was an attempt to clear or transmit an empty buffer.
Lo/hi beep
A successful transmission of buffered data.
Host Specific
USB only
4 short high beeps
Scanner has not completed initialization. Wait several seconds and scan again.
Scanner gives a power-up beep after
scanning a USB Device Type.
scanning a USB Device Type.
Communication with the bus must be established before the scanner can operate at the highest power
level.
level.
This power-up beep occurs more than
once.
once.
The USB bus may put the scanner in a state where power to the scanner is cycled on and off more than
once. This is normal and usually happens when the PC cold boots.
once. This is normal and usually happens when the PC cold boots.
RS-232 only
1 short high beep
A <BEL> character is received and Beep on <BEL> is enabled.