Brother 9200C 业主指南

R E M O T E   F A X   O P T I O N S   ( N O T   A V A I L A B L E   F O R   C O L O R   F A X )

     

Follow the commands below to access features remotely. When you call the 
MFC and enter your Remote Retrieval Access Code (1 5 9  ), the system will 
signal you with two short beeps to enter a remote command.

You can retrieve the Memory Status List from a remote fax machine to see if 
you have any fax messages.

Dial your fax number.

When you hear the beep, immediately enter your Remote Retrieval Access 
Code (

 

 

 ).

When you hear two short beeps, use the dial pad to press 

 

 

.

Using the dial pad, enter the number of the remote fax machine where you want 
the Memory Status List forwarded (up to 20 digits), and then press 

 

.

After you hear your MFC beep, hang up and wait.
Your MFC will call the remote fax machine. The remote fax machine will print 
the Memory Status List.

1  OFF

If you hear one long beep, the change is accepted. If you hear three 
short beeps, you cannot change it because the conditions have not 
been met (Example: registering paging number). You can register 
your fax forwarding number by using 4. FAX FWD NO. (see page 
8-5). Once you have registered the number, the MFC will change 
automatically to FAXFWD:ON mode. Then retrieve a Memory 
Status List by entering 961 (see page 8-4) to make sure that the 
Fax Forwarding number you registered is correct in the List.

2  Fax Forwarding

3  Paging

4  FAX FWD No.

6  Fax Storage ON

You can turn FAX STORAGE to ON or OFF.

7  Fax Storage OFF

1  Memory Status List

Enter the number of a remote fax machine to receive the Memory 
Status List or stored fax message(s). (See page 8-5.)

2  Retrieve all faxes

3  Erase fax from the memory

If you hear one long beep, you can erase fax message(s) from the 
memory.

1  FAX

You can check whether your MFC has received any faxes. If yes, 
you will hear one long beep. If no, you will hear three short beeps.

1  EXT. TEL/TAD

If you hear one long beep, you can change the Receive Mode. 
If you hear three short beeps, you cannot change it.

2  FAX

Exit

After a long beep, you can exit remote retrieval.

You cannot use   and 

 as dial numbers. However, if you want to store a 

pause, press 

.