Vidikron VP-60 用户手册
27
Aspect Ratio Controls
» Aspect Ratio Operation with Computer Signals
Switch to the wide screen mode to expand the 4:3 image to fill the
entire screen.
entire screen.
1. Press the ASPECT button on the remote control.
2. Within 3 seconds...
Press the ASPECT button again.
The screen size switches as follows:
2. Within 3 seconds...
Press the ASPECT button again.
The screen size switches as follows:
STD (4:3)
ANAMPHC
LTR BOX
STD 4:3 mode (4:3 or SXGA 5:4)
The picture has the same size as the normal computer image.
ANAMPHC mode
The image is expanded in the horizontal direction.
LTR BOX mode
When wide signals are input.
NOTE:
Do not leave the displayed in 4:3 mode for an extended period.
This can cause a phosphor burn-in.
Do not leave the displayed in 4:3 mode for an extended period.
This can cause a phosphor burn-in.
Information
■ Supported resolution
See page 106 for details on the display output of the
various VESA signal standards supported by the monitor.
various VESA signal standards supported by the monitor.
■ When 853 (848) dot x 480 line wide VGA *signals
with a vertical frequency of 60 Hz and horizontal
frequency of 31.7 (31.0) kHz are input.
Select an appropriate setting for RGB SELECT mode
referring to the “Table of Signals Supported” on page
106.
* “IBM PC/AT” and “VGA” are registered trademarks of
IBM, Inc. of the United States.
frequency of 31.7 (31.0) kHz are input.
Select an appropriate setting for RGB SELECT mode
referring to the “Table of Signals Supported” on page
106.
* “IBM PC/AT” and “VGA” are registered trademarks of
IBM, Inc. of the United States.
Active
Image
Area
Active Image Area
Active Image Area