Roland VP-770 用户手册
19
Connecting Your Microphone
( MIC)
A microphone is indispensable for performing with the VP-770. The VP-770 models v
sounds by using your voice that’s input via the microphone.
A headset-type microphone is included with the VP-770.
If You’re Using the Included Microphone
(MIC)
Connect it to the MIC jack as shown.
If You’re Using a Phantom-powered Condenser Mic
The VP-770’s MIC jack supports phantom power.
Turn this off if you’re using the included microphone.
Always turn the phantom power off when connecting any device other than condenser microphones
that require phantom power. You risk causing damage if you mistakenly supply phantom power to
dynamic microphones, audio playback devices, or other devices that don’t require such power. Be
sure to check the specifi cations of any microphone you intend to use by referring to the manual that
came with it.
(This instrument’s phantom power: 48 V DC, 10 mA Max)
that require phantom power. You risk causing damage if you mistakenly supply phantom power to
dynamic microphones, audio playback devices, or other devices that don’t require such power. Be
sure to check the specifi cations of any microphone you intend to use by referring to the manual that
came with it.
(This instrument’s phantom power: 48 V DC, 10 mA Max)
Press the [PHANTOM] button.
The confi rmation message will appear.
Press the [F1] (OK) button.
The [PHANTOM] button will light, and phantom power will be supplied.
Immediately after powering up the VP-770, the phantom power supply will be off .
1.
*
*
1.
2.
✍
This instrument is equipped with balanced (XLR/TRS) type jacks.
Wiring diagrams for these jacks are shown below. Make connections
after fi rst checking the wiring diagrams of other equipment you
intend to connect.
1: GND
2: HOT
3: COLD
TIP: HOT
RING: COLD
SLEEVE: GND
RING: COLD
SLEEVE: GND
Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
1. Changing the direction of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
*
*